This process uses water and an abrasive medium accelerated from a nozzle with compressed air to provide a very effective environmentally friendly closed loop surface cleaning.

The glass bead used in the system is mixed with water to a slurry and blasted at the component. The water buffers and lubricates the particles on impact allowing very fine finishes to be produced without damage to the component.

The vapour blasting process is suitable for aluminium, Bronze, Magnesium, Titanium, Brass, Copper etc... It will gently clean the surface without damage and leave a nice satin finish which is very easy to keep clean.

Please be aware that any item that rusts can not be done with this process as the item oxodises instantly.

Note: All bearings & valves etc have to be removed and anything lacquered or painted will need to be stripped prior to blasting as this process is to passive, this can be done by yourselves or by us if you require us to.

When we receive your parts fistly we will remove all bearings & valves etc if required.

Then the parts are placed into a large industrial hot wash for degreasing or if parts require stripping of laquer or paint they will be placed in a dip tank for stripping.

Once all this is done it's time to blast the parts in the vapour blaster to produce that nice satin sheen finish.

The parts are then returned to a hot wash tank to flush through the oil feed galleries etc of any remaining glass bead, once flashed dried on exiting the washer the parts are sprayed with a corrosion inhibitor & packed ready for dispatch.

Whilst every care is taken to ensure there is no glass bead remaining we do advise that you rewash all parts again before fitting.